Showing posts with label downpipes. Show all posts
Showing posts with label downpipes. Show all posts

Dressing the backyard

Landscaping the backyard has been the priority of late. With winter fast approaching we wanted to make sure we weren't going to be walking around in mud once again during the wet season. (especially having recently acquired a new puppy).


We wanted to hide the slim line water tank PD had installed using a material that would blend in with the surrounds. We chose to go with the Merbau and the treated pine frame. Here the holes have been dug and posts are ready to be set in place.


Once the posts were in, some rails were added along with a splash of 'Feast Watson' Merbau decking oil.


Next we added the the Merbau planks.

And 'viola' - the tank is gone!


We decided to go with a different landscaper to help us with the remaining works in the backyard. This time we enlisted the services of Ben Proctor from 'Vision Designscape Solutions'. He was really helpful in providing ideas and nothing was too difficult. We had decided earlier that we wanted install instant turf using a buffalo grass called 'Palmetto'. Ben had to re-route some of the house drainage as it sat too high in the ground and would have been damaged during the soil preparation. Additional 'aggie' pipes were also included to assure us that no problems would arise during the wet season. The downpipes from the Shed and additional aggie pipes around the retaining wall were all linked to the storm water drain.

Once the fresh top soil had been laid, Ben went about installing the drip line irrigation. The existing water tank (no, not the one shown earlier, another one, used for irrigation) was tapped into to provide water to the lawn and also to feed the garden beds which will be shown later.

A double solenoid system was installed under the deck which runs back to an automated timer running off the tank and pump. One drip line feeds the lawn while the other feeds the garden beds. The solenoids are shown below.


This is the solenoid timer/controller - a Hunter 6-station outdoor controller.


Here you can see the drip lines being tested.


Once the system was connected the turf was brought in and laid. A sand pit for the cherubs was also included which is nicely tucked away in a corner. Something which can later be removed and more turf added to fill the void once they grow out of it.


Next, we needed to finish off the top level by installing the steppers and garden beds. 500x500mm concrete pavers were used to create a path from the Alfresco area to the shed and side of the house.


Weed mat was laid around the pavers to minimise maintenance.


River pebbles were used this time to fill the areas around the pavers.


The downpipes of the shed were plumbed into the aggie drains.




Then the top soil and mulch were carted in and filled into the garden beds.




Once in, we set about selecting the plants and having them installed.

A feature Agave (or Foxtail Agave) was included close to the deck to prevent little ones stepping off accidentally.


Six 'Silver Sheen' Pittosporums were added to line the wall.


Dotted throughout the garden bed we also incuded smaller agave's, Blue Fescue and Guzmania Bromeliads (below).



Along the fence line we included eight 'Strelitzia Reginae' or 'Birds of paradise' plants with 'Arthropodium cirratum' or White Night. as fillers in between as shown in the pic below.




Along the Shed wall we added some espalier fruit trees; a lemon, an orange and in the middle, an olive tree.


Once all the plants were in we installed 6 low voltage halogen lights running off a dusk timer which can be set to remain on for 2, 4, 6 or 8 hours or till dawn.


Before...


...and after.


So that takes us to where we are now, a low maintenance, purposeful backyard where the Cherubs can finally run around with the dog and kick a ball or two.

A massive thanks to Ben (and Blair) for their efforts in turning this backyard into our little tropical paradise.

15-7-08 Shower hobs and Heaters

Well the last week has been a pretty slow one.
The only visible difference was that the shower hobs had been started....




...and the downpipes have been connected to the storm water drains.


A couple of holes have appeared in the corridor walls - the plasterers or maintenance folk are gonna have to fix this one up. (maybe someone spat the dummy?)


The piles of rubbish are mounting up slowly too. I can’t believe how much plaster they throw out!


As mentioned in previous posts we have not opted for additional heating vents in the Ensuite and bathrooms, so I recently went out and purchased a pair of wall mountable heaters. They are 'IXL Tempo’s' and here are the specs:
• Instant, fan-boosted heat
• 2 heat settings: 1000W and 2400W
• 2 over-temperature safety devices
• "A" rated energy saving economical operation
• Colorbond steel construction
• Portable or optional wall-mount
• Recessed carry handles
• Thermostat heat control
• Suits rooms up to 50m3
• 2 year warranty
• Australian made


For the room size they will be heating, these will be ideal, and this way when getting up at the crack of dawn to go to work I won’t need to heat the entire house to have a shower ;-). Oh, and the little feet on the base of the units screw off too when you wall mount them.

I also picked up an IXL Turbo model off eBay for a great price for the garage/workshop too!